Suavinex Bottle Silicone Teat 3 Positions 240ml

Directions for Use:

1. Before first use, sterilize all parts of the bottle (bottle, teat, and cap) in boiling water for 5 minutes or using a sterilizer approved for baby bottles.
2. Wash your hands thoroughly before preparing the formula or breast milk.
3. Prepare the formula or breast milk according to the manufacturer's instructions or your pediatrician's recommendations.
4. Fill the bottle with the desired amount of liquid, being careful not to overfill.
5. Attach the silicone teat to the bottle, ensuring a secure fit.
6. Check the temperature of the liquid on your wrist before feeding your baby. It should be lukewarm.
7. Hold the bottle at an angle that allows the teat to fill completely with liquid to prevent your baby from swallowing air.
8. Select the desired flow rate by turning the teat to align the corresponding mark (I, II, or III) with your baby's nose.
9. After each use, disassemble the bottle and clean all parts thoroughly with warm soapy water and a bottle brush.
10. Rinse all parts thoroughly with clean water and allow to air dry completely before reassembling.

Recommended Frequency:

This bottle can be used for every feeding as needed.

Additional Tips:

Inspect the teat regularly for any signs of wear or damage and replace it if necessary.
Do not heat the bottle in a microwave oven.
Always supervise your baby during feeding.
Discard any remaining formula or breast milk after each feeding.
This bottle is compatible with other Suavinex teats and accessories.
For any questions or concerns, consult your pediatrician.